Hello, I am a fabricator/installer located in the high desert (Palmdale) in So Cal. I have a project I'm working on that will require some water jet cuts in some 2cm Ceasarstone slabs. I am hoping to find a shop that I can sub this out to. any help is greatly appreciated. Thanks in advance Jack O'Co...

I used to be a member years back, kind of dropped out of fabricating for a while due to the fact that I had to get a regular job to feed my kids :/. I have been fabricating for 10 years, now I only do it on a part time basis but things have gotten busy again as far as that goes and will be joining b...

I always cut them with an overhang mostly because a lot of these sinks are not finished all the way up to the flange if you cut them flush you run the risk of having unfinished porcelain exposed plus its less maintenance on the sealant if its not exposed to the water all the time

So Im ready to chuck my old school manual seam setters and step up to good set so here's the question... Omni cubed stealth seamer or gorilla grips 2.0? Both are priced about the same and I have read a bunch of reveiws but I am still on the fence. so if you were gonna drop almost a 1K on a seamer wh...