Pro-Edge III tough screen
Our touch screen is on the fritz, and we wanted to know if there is an alternate for the pricey factory replacement. :[-o<
-
graffster
- Posts:588
- Joined:Tue Oct 27, 2009 8:13 am
- Location:boise, Id.
- Has thanked: 1 time
- Been thanked: 5 times
Re: Pro-Edge III tough screen
When I ran one the screen had a plastic protector over it and got some water behind it and made it not function right pulled plastic off and bam like new never had any problems after. Hope that helps
George M. Graff SFA
Stone Pro Restoration & Repair Inc.
4741 Glenwood St. BLD. C
Garden City, Id. 83714
Cell 208-284-3984
Fax 208-853-2793
george@stoneproid.com
Stone Pro Restoration & Repair Inc.
4741 Glenwood St. BLD. C
Garden City, Id. 83714
Cell 208-284-3984
Fax 208-853-2793
george@stoneproid.com
Re: Pro-Edge III tough screen
Got it going yesterday. We took the screen protector off and re-calibrated it just to get it running. After a second re-calibration, it seems to be working normally. Even though the screen protector looked clean, there must have been something on it. Thanks, guys.
-
pwukusick
- SFA Member
- Posts:502
- Joined:Sat Nov 14, 2009 9:17 pm
- Location:Batesville, IN
- Has thanked: 7 times
- Been thanked: 12 times
- Contact:
Re: Pro-Edge III tough screen
For future reference I had a board go bad in mine and had it repaired at the manufacturer (Mitsubishi I think it was). It cost $1100 or so with shipping, but still better than the $4000 I was quoted from park for a new one. There was a one year warrantee on the repair also.