Epoxy bleeding into white marble

[Jlixey]

Wondering if anyone out here knows a way to draw out the bleeding or minimize it. We have an Island that has a small spot on the mitered edge that looks to have bleed into the marble. Also what epoxy is everyone using on mitered white marble?

[ageless]

We use Glax on all white marbles.

[luke getz]

we have been using the touchstone glacier for marble ( and other stones) and we like it.one of the reasons i like the glacier over the glax is that the mixing ratio is not as critical. we also use integra magic for seams.

[Jonathan]

We have been using Integra Transparent White, it already comes mixed and does not bleed. It works perfect for marble miters and laminations.

[Jlixey]

Thanks i will do some R&D on these. How about drawing out bleeding of a piece already made?

[Stone Dude]

We switched to Bonstone Touchstone Glacier. It's a urethane. Doesn't bleed and is UV/moisture stable.

[luke getz]

I dont know of a way to pull that out. but then I have not really tried either. maybe someone else has found a way

[Alex DiPietro]

Hit the bleed lightly with a torch and immediately wipe with acetone. I've minimized some bleeding using that method... We use Tenax Crystal for white marble miters exclusively, but we just hit the edge with a bit of sealer first to stop this from happening. And we miter a ton of white marble.

[michaelcheaney]

Heat,then use acetone to draw it .will fade but wont remove.