Page 1 of 1
Braking System for Rotating Table
Posted: Wed Apr 12, 2017 3:33 pm
by Scooter
Does anyone have some type of braking system they want to sale for an old rotating table the problem is it is loose so when you make long cuts it moves alittle.The table is a park industry's hydraulic rotating table with NO brakes.
Re: Braking System for Rotating Table
Posted: Wed Apr 12, 2017 5:15 pm
by Ken Lago
Very simple. Weld a big nut to the frame then weld a handle to the bolt, loosen when you want to rotate and tighten when you want to cut.
Re: Braking System for Rotating Table
Posted: Fri Apr 14, 2017 4:51 pm
by Alex_Bores
Ken Lago wrote: ↑Wed Apr 12, 2017 5:15 pm
Very simple. Weld a big nut to the frame then weld a handle to the bolt, loosen when you want to rotate and tighten when you want to cut.
[
We did this on an old saw. Very simple and cheap