SFA

I purchased a used 2004-2007ish Emmedue Astra Saw. After wiring saw and connecting air we discovered the pneumatic locking pins where seized in the up or "locked" position keeping the table from turning (manual turning table). Today we removed all piston cylinders so nothing was in place to keep it "locked" in any position. After doing so we still can not get the table to spin. We even tried "bumping" it with the forklift to force it free. Am I missing something? Please give me any advice. My next option is to remove the table decking and start disassembling the main housing unit under the table. I referred to the manual and verified it as a manual spinning table with only pneumatic stops. Tilt function works properly however only 3 planks raise not the whole table surface so to get to the main body of the table will require taking off all the planks / boards, hardi backer. Please email me thoughts jon.hart85@yahoo.com