Please help with Fusion Alphacam

[Mehomarble]

Hi,
We just bought Fusion/Park Industries and we are struggling with simple drawings.
Could someone please walk me trough how to cut 37" x22.5" vaniti with sink centered at 18" from the right. We have overhead camera. Sink is Kohler 2355-0.
Thank you so much!
Mehome

[GuyboR]

Hi,
We just bought Fusion/Park Industries

Did you buy new or used?

If new....call Park and they should be able to help you out.

If used...call Park and pay for training so that you can get running efficiently.

[Mehomarble]

it is new, and we did call Park but with the holidays it is very hard to get some help. I thought this forum might be faster way because we are stock and desperate.

[GuyboR]

It's not really a holiday....yet.

There are a few Fusion users on here and hopefully they can help you out.

It will help also if you fill in your signature line so everyone knows who you are and where you are from.

[btimike]

I can try and help if you still need? we run a fabcenter but it should be similar if not using jet.

[crisco]

i can help.

[crisco]

here ya go. email me if you need help still cwborland@gmail.com. i program after hours too