Page 1 of 1
Temperature sensor for spindle on Brembana Maxima?
Posted: Tue Oct 08, 2013 8:45 am
by Lord Preston
I am just wondering if anybody knows if there is a temperature sensor on a Brembana Maxima Spindle and if so how to read it?
Our machine has downtime throughout the day and I'd like to know when a warmup may or may not be required a the day goes on..
Thanks
N.
Re: Temperature sensor for spindle on Brembana Maxima?
Posted: Tue Oct 08, 2013 11:33 am
by Cevin Moberly
There is a high temp sensor inside the spindle but it is not readable.
If your machine is off for a few days and it's been cold in your shop, a short warm up cycle is recommended. This is to neutralize the internal temp of the grease and bearings. multiple time per day is not necessary.
Cevin
Re: Temperature sensor for spindle on Brembana Maxima?
Posted: Sun Oct 13, 2013 8:25 pm
by Matt Lansing
Considering where you guys are located a warm up cycle is probably required year round!
You could just make a simple spindle warm up cycle and run it whenever you think it has been sitting too long.
For the record, we have never used a warm up cycle on our machine and we typically have spindles go over 10,000 hours and they usually are changed out for things other than bearing issues.