SFA

Anyone using and S-lazer to set pods on an intermac ? I can get the the part projected but not the pod location.
Any suggestions ?

Thanks in advance
Bob Faust

Can you change your pods to the same layer as your part?

According to Intermac this can not be done with Icam ,That's why im trying to see if anyone has found a way.
I guess you can chalk that up to "good to know before we purchased Lazer".

couldnt you just draw squares or circles on a separate cad drawing and replicate the pods that way ?

I would make a separate folder with all your pod sizes in it pre-drawn and just import them in instead of using the machine section. Similar to how you would import a sink shape.