brazed seam wheels

clhilde · Post by **clhilde** » Fri Mar 16, 2012 1:55 pm

feeds and speeds please

Joshua Hopkins · Post by **Joshua Hopkins** » Fri Mar 16, 2012 2:06 pm

4500 rpms 1.5-2meters a min

clhilde · Post by **clhilde** » Fri Mar 16, 2012 2:27 pm

thank you sir

Joshua Hopkins · Post by **Joshua Hopkins** » Fri Mar 16, 2012 2:29 pm

That is about what I use just watch your amp draw and listen to the machine you will get a fill those numbers should get you in the ballpark.

Bretth · Post by **Bretth** » Fri Mar 16, 2012 3:35 pm

1.5-2 meters min.... 60-80" min.... Damn you guys haul balls. 5000RPM's 25" min here

VThartzog · Post by **VThartzog** » Fri Mar 16, 2012 7:16 pm

4000 rpms at 1.2m. I hardly can hear them run.

DavidL · Post by **DavidL** » Sat Mar 17, 2012 12:05 pm

5000rpm, 1m/min I always saw 110meters of use before they stopped cutting and started pushing.

Visit our Guardian Sponsors