Denver Skema monoframe saw $12K USD SOLD SOLD SOLD
Posted: Mon Dec 04, 2017 11:21 am
I have had this saw sitting for a couple of years - I have been moving in and out of my storage shop and it is a pain in the butt - Its worth more but I just want it gone. I have all new Breton equipment, and although I kept this as a backup, it appears as though I will never need it.
Because its a monoframe, you just have to hook up the 208/220V power, add water and viola - no leveling etc needed.
There are pop up wheels that allow you to move slab around on the table - this was covered with the 2x6s and we never cut the holes for the popups as we used a vacuum lift. Will do miters etc. Table does not tilt. Water can be automatic but a sensor went and we just ran it manual.
We can connect it to power if anyone wants to visit and see it run.
download/file.php?mode=view&id=16563htt ... w&id=16564
Because its a monoframe, you just have to hook up the 208/220V power, add water and viola - no leveling etc needed.
There are pop up wheels that allow you to move slab around on the table - this was covered with the 2x6s and we never cut the holes for the popups as we used a vacuum lift. Will do miters etc. Table does not tilt. Water can be automatic but a sensor went and we just ran it manual.
We can connect it to power if anyone wants to visit and see it run.
- denver.jpg (192.76KiB)Viewed 193 times