SFA

There, I said it. My girl doesn't care for the fancier new bits you guys like. Probably due to marginal water volume thru the spindle and the fact that I am always cutting fully engaged.

The smaller diameter bits are my preference, and they gotta be inexpensive. Think 5 guys going to Hardees type money

Any of you guys closing out anything let me know.

Ebay

When I go to ebay all I see are used fingerbits with a $75 reserve on them.

I need to get lucky like Scott did a while back.

Chris,
Check this one out. I found out about this form Scott @Kasco. For the price you can't go wrong and they last a decent amount of time. https://www.galaxytoolsupply.com/Produc ... tCode=7500 Even if they are out of stock call them they may have them some place else and be able to get them to you quick.

Hi Chris,
I sent a pm, but thought I would post here too.

Please check out my website: Cheapstonetools.com, we have a lot of new over stock finger bits starting at $ 21.60 each.
Here is the link: http://cheapstonetools.com/node/699
Make me an offer on volume purchases - We are very long in these, that is why they are so cheap.

Disclaimer:
These are cheap finger bits. Some people like them and some do not.
You generally get what you pay for. There have been some quality control issues with these, but
most of them will run fine.

Call me directly with any questions or for volume purchases.

Eric Hanson
Granite City Tool
320-761-1449
eric@granitecitytool.com

Chris I have some low cost bits on clearance as well you might want to take a look at. If your interested lmk.

Thanks to everyone.

Now I encourage all of you guys with nice tight proper CNC's to run the poop outta the fancy new bits. Stroke them at 750 mph and get it done.

Have fun.

Our website is not quite finished but we would be happy to help you out with some choices we have. My info is at the bottom and Customer Service is 800-845-1805.

The cheapest best bit I have found were the fingerbits I bought from Diamont Boart - JC Collins, There were red and 5 segments. I think they were around $69 or less new and they performed almost as good as my orange mills from ADI at $100 a bit. I did have to slow down the feed a bit.