Fab King vs Park Wizzard

[TS Stone]

I am looking at getting either a Fab King or Park Wizard for mainly sinks and some edging. I like the splash polish feature on the Fab King, but would like to get your guys opinion on these machines. Not sure I want the expense of the cnc yet. I am upgrading other machines that are dated. I have an older cnc but needs some work and we get our bottle neck at the sinks and splashes. I tend to have some of my better fabricators end up doing sinks & splashes to get the job completed, when they would be better served on the next job.

Your feed back is greatly appreciated...

[Dave.Scott]

I am not familiar with the Fab King.
We ran a Wizard for years, had plastic templates made for the most common sinks.
The two spindle set up on the Wizard was nice, high speed for cutting and low speed for polishing.
We do a bit of honing and brushing with it too.
Should be able to find a used one out there for $10k or so.

[TS Stone]

Thanks

[Dan R.]

for sinks, we bought a small Ghines cnc for $40k. manual tool change, but perfect cut & polish.

For splash think about a used Flying Flat for $20k it will polish at over 60ft/hr.

Both would require less fabricator time than either a Wizard or Fab King.

[MattB]

I can't tell you much about the Wizard but we sell the Fab King. I'm happy to answer any questions you may have or put you in contact with someone who is rocking one. Feel free to contact me.
Good luck!

[HELIOS ITALY]

Hi,

this is Francesca for Helios Automazioni Italy.
Have you already found a solution for your workshop?
May I have the chance to introduce our products after understanding your needs?
In the meantime, if you want, you can have a look to the catalog here:
http://www.heliosautomazioni.com/brochu ... alogue.pdf
Feel free to contact me anytime or the Sales Manager Daniel also on whatsapp +393485411551.
Have a great day!