Hey guys,
Im engraving an island.. The island will be face/polish down. I will being engraving lettering 3/4 of the way through the piece then I will be mounting LED lights in the lettering so the light shines from the bottom through the top of the piece. My issue is in AUTOCAD and EasyStone I am unable to mirror the letters individually. I can mirror the Word however each letter stays going the normal left to right direction. Obviously the letters that are not symetrical, would be backwards when my guys install the island. Any Suggestions on how to mirror each letter?? Im stuck on this one.. Thanks
Engraving**assistance**
-
Jqualey4130
- Posts:298
- Joined:Tue Nov 10, 2009 10:18 am
- Location:Bangor ME
- Has thanked: 1 time
- Been thanked: 8 times
-
Omni Cubed Larry
- SFA Sponsor - Friend
- Posts:723
- Joined:Mon Apr 26, 2010 2:35 pm
- Location:Shingle Springs, CA
- Has thanked: 244 times
- Been thanked: 175 times
- Contact:
Re: Engraving**assistance**
I haven't used AutoCAD in many years.
DOS was the operating system, so that dates me a bit.
I am pretty sure you can type MIRRTEXT at the command prompt and change that variable.
<0> keeps the text readable after being mirrored
<1> allows the text to actually mirror
Switch it to 1 and you will be in business.
Let me know if that works!
DOS was the operating system, so that dates me a bit.
I am pretty sure you can type MIRRTEXT at the command prompt and change that variable.
<0> keeps the text readable after being mirrored
<1> allows the text to actually mirror
Switch it to 1 and you will be in business.
Let me know if that works!