Fab king working for any one?

[Stonedesign tops]

Wanting to speed up my production how can this machine help?

[GlobalEquipment]

We have sold several of these machines to our customers and all have been very pleased with it. It is a great stepping stone until you go in to the CNC world. If you go on the website below you can see several different videos of the machine in operation.

http://www.rye-corp.com/

[Caleb]

We're on the road to going digital. We have a fab king we will sell sometime in the near future if you're interested.

Thanks - Caleb

[977TOPS]

They work great. The only concern that I see is the ability of making templets. We have had one for several years love it but we also fab solid surface and have a cnc for that, and can cut our own templets.

[Caleb]

With a piece of solid surface or hdpe, a couple clamps and a router with a bottom bearing bit you can make a template for any sink in about 30 minutes.... having a cnc in your solid surface shop sounds easier though!!

[luke getz]

we make sink templates from plywood - we attach the sink to the plywood and then use a bottom bearing 1/2" flush cut wood router bit with a bb300 bearing ( it has a nylon sleeve and is slightly larger than the bit so your template will have about a 1/8" overhang past the sink) it works good, just make sure to hold the bearing tight against the sink so it does not start spinning or it might leave a slight mark on the sink